Tree 2uvr-c quill handle, z clutch
Quill handle on the Tree was missing the stuff that holds the handle on. The
parts book is not clear on what it should look like. There was the vestige of a
spring left. Guessed and made a spring and retainer that will allow the handle
to come out and reindex where you want it. I used a 5/16 bolt with the head
turned to .430 round and a random spring bent to fit. The spring must have been
held in place because one end was bigger and fit behind the lip of the hole in
the end of the shaft. You can wind it in and it stays.
Made a brass washer to fit, a cadmium plated nut and a brass acorn nut to hold
it on with a little preload. The handle pulls out and will hold after
reindexing. I'd like to see what it looked like from the factory.
The Z clutch wouldn't work, found it was missing a pin. Two were there so I made
a match.
The pins go in and push on a cone clutch.
No comments:
Post a Comment